Table of Contents
Advertisement
xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
create access_profile (for Ethernet)
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a Ethernet access profile:
DGS-3324SRi:4#create access_profile ethernet vlan 802.1p profile_id 1
Command: create access_profile ethernet vlan 802.1p profile_id 1
Success.
DGS-3324SRi:4#
config access_profile profile_id (for Ethernet)
Purpose
Used to create an access profile on the Switch by examining the
Ethernet part of the packet header. Masks entered can be combined
with the values the Switch finds in the specified frame header fields.
Specific values for the rules are entered using the config
access_profile command, below.
create access_profile [ethernet {vlan | source_mac <macmask
000000000000-ffffffffffff> | destination_mac <macmask
000000000000-ffffffffffff> | 802.1p | ethernet_type} profile_id
<value 1-8>}
This command will allow the user to create a profile for packets that
may be accepted or denied by the Switch by examining the Ethernet
part of the packet header. Specific values for rules pertaining to the
Ethernet part of the packet header may be defined by configuring the
config access_profile command for Ethernet, as stated below.
ethernet - Specifies that the Switch will examine the layer 2 part of
each packet header with emphasis on one or more of the following:
vlan − Specifies that the Switch will examine the VLAN part of
•
each packet header.
source_mac <macmask> − Specifies a MAC address mask for
•
the source MAC address. This mask is entered in the following
hexadecimal format: 000000000000-FFFFFFFFFFFF
destination_mac <macmask> − Specifies a MAC address
•
mask for the destination MAC address in the following format:
000000000000-FFFFFFFFFFFF
802.1p − Specifies that the Switch will examine the 802.1p
•
priority value in the frame's header.
ethernet_type − Specifies that the Switch will examine the
•
Ethernet type value in each frame's header.
profile_id <value 1-8> - Specifies an index number between 1 and 8
that will identify the access profile being created with this command.
Only administrator-level users can issue this command.
Used to configure the Ethernet access profile on the Switch and to
define specific values for the rules that will be used to by the Switch
to determine if a given packet should be forwarded or filtered. Masks
entered using the create access_profile command will be
combined, using a logical AND operational method, with the values
the Switch finds in the specified frame header fields.
214
Advertisement
Table of Contents
