D-Link xStackTM DGS-3300 User Manual page 184

xStack DGS/DXS-3300 Series Layer 3 Stackable Gigabit Ethernet Switch CLI Manual
show ssh user authmode
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the SSH user:
DGS-3324SRi:4#show ssh user authmode
Command: show ssh user authmode
Current Accounts:
UserName
--------------------------
Trinity
DGS-3324SRi:4#
config ssh algorithm
Purpose
Syntax
Description
Parameters
Used to display the SSH user setting.
show ssh user authmode
This command will display the current SSH user setting.
None.
None.
Authentication
--------------------------
Publickey
Note: To configure the SSH user, the administrator must create a user
account on the Switch. For information concerning configuring a user
account, please see the section of this manual entitled Basic Switch
Commands and then the command, create user account.
Used to configure the SSH algorithm.
config ssh algorithm [3DES | AES128 | AES192 | AES256 |
arcfour | blowfish | cast128 | twofish128 | twofish192 |
twofish256 | MD5 | SHA1 | DSA | RSA] [enable | disable]
This command will configure the desired type of SSH algorithm used
for authentication encryption.
3DES – This parameter will enable or disable the Triple_Data
Encryption Standard encryption algorithm.
AES128 - This parameter will enable or disable the Advanced
Encryption Standard AES128 encryption algorithm.
AES192 - This parameter will enable or disable the Advanced
Encryption Standard AES192 encryption algorithm.
AES256 - This parameter will enable or disable the Advanced
Encryption Standard AES256 encryption algorithm.
arcfour - This parameter will enable or disable the Arcfour encryption
algorithm.
blowfish - This parameter will enable or disable the Blowfish
encryption algorithm.
cast128 - This parameter will enable or disable the Cast128
encryption algorithm.
181