Actually Routing The Insert To A Mixer Channel - Tascam SX-1 Reference Manual

Actually routing the insert to a mixer channel

Once you have created an insert on the insert routing
page, you'll want to actually insert it on a mixer
channel to hear it. While you can do this in a few dif-
ferent places on the VGA, the manner of selection is
the same for all of them.
Right-clicking on the
Insert
dialog:
The same button can be
viewed on the VGA
Channel
screen, as seen to the right.
button will bring up this
Part IV–Mixer Controls
Go back to the Mixer page (
section of the surface, or press
DISPLAY MODES
Alt+2 on the PS/2 keyboard), and look at the top of a
channel strip for the
Insert
Here, you can select which insert the channel in
question actually uses – as well as determining
whether the insert is pre- or post-EQ. Each channel
can access one insert at a time, and the last selection
will send the view back to the
tab.
Presets
To use the insert, click the insert button normally
(with the left mouse button). The button will light red
to indicate that the insert is active.
TASCAM SX-1 Reference Manual
key in the
MIXER MAIN
button:
screen's
Routing Insert
61