Tascam SX-1 Reference Manual page 87

To operate the touch function:
Enable write mode.
1
Press and hold the
2
TOUCH
While holding the
3
TOUCH
trol to begin overwriting the existing previ-
ous mix moves for that control.
Release the
4
TOUCH
ues to write until a new move is written or
until is pressed.
REVERT
If a new move is written, the revert action
follows the settings made on the
screen.
REHEARSE/ALL SAFE
key enables the write automation Rehearse
SAFE
mode.
Press +
SHIFT REHEARSE/ ALL SAFE
automation from being written at all. This All Safe
mode places all controls on the mixer into Safe. The
result is that no automation can be written and mov-
ing a control will not affect the audio going through
that control.
Use the
WRITE/INIT EDIT
to enable Global Write mode. The Write mode must
be enabled (as indicated by the
key's associated LED) in order for touch automation
to function. Press +
SHIFT
the Init Edit mode.
key.
key, use the con-
key. The control contin-
AUTO MAIN
The
REHEARSE/ ALL
to prevent
key
WRITE/ INIT EDIT
WRITE/ INIT EDIT
to enter
WRITE/ INIT EDIT
Part IV–Mixer Controls
Init Edit allows editing of any control's initial status
as described above. Exiting Init Edit saves the edit.
There is no Undo for this operation. The
is used to Undo an Init Edit (see below).
DISCARD
TRIM/INIT DISCARD
key enables the Global Trim mode. Trim automation
allows you to add or subtract values from your cur-
rent automation data. For example, if automation
data already exists, entering the Trim mode and than
pushing the fader up will add this extra value to the
track's already recorded automation. Pressing
+ throws out any changes
TRIM/ INIT DISCARD
made while Init Edit is active. This must be done
before exiting the Init Edit status.
REVERT/AUTO FADE
any controls currently Writing or Trimming to exit
Write/Trim and transition back to the setting they
held prior to the Write or Trim operation. The
amount of time taken for this transition is determined
by the setting of the Write Revert Time and Trim
Revert Time parameters.
+
SHIFT REVERT/ AUTO FADE
the Master Fader out over a specified time (this time
is also set from the tab). Auto Fade operations
Global
must be performed in either Write or Trim mode.
Auto Fade operations may be rehearsed using the
Rehearse mode.
TASCAM SX-1 Reference Manual
INIT
The
TRIM/ INIT DISCARD
SHIFT
Press to cause
REVERT
automatically fades
87