Disabling Control Sense Timeout; Trimming Mix Moves - Tascam SX-1 Reference Manual

Part IV–Mixer Controls
Disabling Auto Revert
stop writing switch events, either by stopping the
transport, or by pressing the
key. In this situation, all controls that are writing will
1 sec
+12
Switch ON
+6
+3
0
-3
-6
-12
1 sec
+12
+6
+3
0
-3
-6
-9
-12
1 sec
+12
Switch ON
+6
+3
0
-3
-6
-9
-12

Disabling Control Sense Timeout

Control Sense Timeout is a subset of Auto Revert in
that it only affects non touch-sensitive controls. By
disabling Control Sense Timeout, it is possible to
begin writing on a switch or rotary encoder and have
that control continue writing, while new fader moves
are performed with Auto Revert. It is necessary to

Trimming Mix Moves

There may be times when a control has existing mix
moves that are good, but the overall level of those
moves needs to be raised or lowered. In this situa-
tion, Trim is used to offset existing moves.
102
TASCAM SX-1 Reference Manual
allows you to manually
REVERT/ AUTO FADE
Existing Switch Events
2 sec 3 sec
4 sec
Switch OFF
New Switch Events
2 sec 3 sec
4 sec
Switch OFF
Resulting Switch Events
2 sec 3 sec 4 sec
Switch OFF
stop writing simultaneously when
is pressed or play stops.
FADE
Below is an example of Writing new switch events
over previous switch events with Auto Revert dis-
abled:
5 sec 6 sec 7 sec 8 sec
Switch ON Switch ON
Switch OFF
5 sec 6 sec 7 sec 8 sec
Press REVERT
7 sec
5 sec 6 sec 8 sec
Switch ON
manually revert controls that begin writing with Con-
trol Sense Timeout disabled.
It is possible to enable or disable Control Sense Tim-
eout on a single mix pass for flexibility in ending the
write in the same way that Auto Revert can be
enabled or disabled on a single mix pass.
Before or after pressing
section) so that its indicator lights.
AUTOMATION
Perform your desired Trim operation.
With the mixer in Trim mode, any movement of a
control while timecode is running performs a Trim
REVERT/ AUTO
, press (in the
PLAY TRIM