Vga Transport; Lcd Transport - Tascam SX-1 Reference Manual

Part III–Locate, Transport, & Surround
Immediate In this mode, the SX-1 stops after any
locate operation.
Automatic In this mode, the SX-1's transport will
immediately engage PLAY after any locate opera-
tion.
Deferred When the SX-1 is controlling external
devices, pressing PLAY during a locate operation
results in playback starting after the locate operation
is complete.

VGA Transport

Transport controls that mirror the front panel Trans-
port Keys are available in the VGA screens' Main

LCD Transport

A variety of external devices can have their trans-
ports controlled directly from the SX-1's Transport
Keys.
Opens the screen where you can
LOCATE POINTS
manage Locate Points ("Locate Points" on page 38).
Opens the
REGISTER
REGISTERS
can view and adjust Loop, Autopunch, and Audition
points.
Use this screen to manage
EXTERNAL DEVICES
the SX-1's transport communication with external
devices.
This parameter determines which
REC CHANNEL
channel strip on the SX-1 will act as the first channel
for remote track arming. The above example has
Channel 17 set for this value.
32
TASCAM SX-1 Reference Manual
screen where you
This keym rewinds the project.
REWIND
This key , fast forwards the
FAST FOWARD
project.
This key ª stops playback.
STOP
This key Á starts playback and punches out
PLAY
of Record.
With a track record enabled and the trans-
RECORD
port in PLAY, press this key º to punch in.
Menu Bar. The Record key displays an "M" when
Mixdown Mode is enabled.
This knob sets the project frame
FRAME RATE
rate. Rates of 30, 29.97, 29.97 Drop, 25, and 24
frames per second (fps) are available. To change the
current frame rate, you must select
from the tab that appears at the right of the screen.
SMPTE/TIMECODE OFFSET
determines the amount of offset from incoming and
outgoing timecode. Values can be entered by using
the keypad.
Turning the knob accomplishes two things: the knob
now acts as a cursor for the offset register (moving
the cursor from hours to minutes to seconds, for
instance), and it opens a dialog strip on the right side
of the LCD screen:
TOGGLE SIGN
pressed, the offset value changes from a
positive offset (
meaning that an offset of
would play back two seconds later than
the device generating the timecode, and
that an offset of
back two seconds earlier.
CURSOR <---
left by one value.
CURSOR --->
right by one value.
This key toggles the offset dis-
SMPTE FORMAT
play to show one of the four timecode choices avail-
able in the SX-1.
or
Accept Cancel
This parameter
When this key is
) to a negative offset ( ),
+ -
+00:00:02:00
would play
–00:00:02:00
Moves the cursor to the
Moves the cursor to the