Digital I/O Settings; Lcd Digital I/O Screens - Tascam SX-1 Reference Manual

Part VIII–Data Entry, System & File Management

Digital I/O Settings

When you have another digital audio device hooked
up to the SX-1 via its
DIGITAL I/O
make sure that the SX-1's I/O matches the other
device's I/O settings. These parameters can be
adjusted from the LCD screen.

LCD Digital I/O Screens

From the
MAIN DISPLAY MODE
, and use the
SETTINGS/ PREFS
) soft key to scroll to the
PAGE
the appropriate soft keys to jump to the Digital I/O
you want to set. The default screens for the onboard
S/PDIF jacks are shown below.
190
TASCAM SX-1 Reference Manual
jacks, you want to
section, press
(or
NEXT PAGE PREV
screen. Then, use
DI /O
TIP
The SX-1 can perform sample rate conversion (SRC) in
real time via the SDPIF inputs. For example, if your
project is at 48kHz but you want to input something
that was recorded at 44.1 kHz, set the SX-1's digital
input to 48 kHz.
Turns the input sampling frequency
FS CONVERT
conversion on or off. When on, sampling frequencies
from 32kHz to 48kHz are automatically converted to
the current mixer sample rate.
Overrides the current mixer sample
FS OVERRIDE
rate, if sample rate of the source at this jack is
different.
Normally, when the SX-1 detects
MUTE DEFEAT
a clock outside its limits of tolerance (±6%) from the
nominal sample rate of that source (e.g. a varispeed
source), the console mutes. This setting allows you to
defeat this operation.