Buss Routing; Input Button; Insert Button; Trim/Ch Delay Screen - Tascam SX-1 Reference Manual

Part IV–Mixer Controls

Buss Routing

selected channel's Buss Routing dialog:
1-2 to 7-8 Use these buttons to send sig-
nals from the selected channel to busses
1-8.
CUE Use this button to send signal from
the selected channel to the Cue buss.
ST Use this button to send signal from
the selected channel to the Master stereo
buss.
This menu houses the controls for

INPUT button

phase polarity and EQ/dynamics order.
This menu houses the controls for

INSERT button

switching the insert on and off, insert number and
point selection.

TRIM/CH DELAY Screen

delay controls are available from the LCD. The trim
controls are different from the pre-mixer channel
input trim controls found on the top of the SX-1.
These trim controls allow you to adjust the level of
mixer channels from –20 to +20 dB before it reaches
52
TASCAM SX-1 Reference Manual
This button opens the
Trim and channel
the fader. The delay function lets you delay individ-
ual channels from 0 to 8191 samples. On the VGA,
the trim and delay controls are found on the
module of the screen.
Channel
To reach this screen, press the
the section. To reach a channel, press
LCD ACCESS
the soft key next to the Trim or Delay group that the
channel belongs to. To select a channel for editing,
use the keypad's up/down arrow keys.
Use this key to copy the delay and
COPY TO ALL
trim settings of the currently selected channel to all
of the mixer's channels.
POSITION
key in
DELAY/ TRIM