Lcd Meter Screen; Lcd Miscellaneous Screen - Tascam SX-1 Reference Manual

LCD Meter Screen

Several LCD screens are available for setting prefer-
ences. Many of these screens have parameters that
are only accessible via the LCD.
The screen is such an example. This screen is
METER
used for setting the responsiveness of the SX-1's
LED meters.
Press on the Keypad. Then, from the
SHIFT
section, press
DISPLAY MODE
and use (or
NEXT PAGE PREV PAGE
the screen.
METER
PANEL METER TYPE
front panel LED Master Meter. Use it to select
between (meters reflect an average of signal
Average
levels), (the peak LED holds for a few seconds),
Peak
or (shows peak and average meters at the same
Both
time).

LCD Miscellaneous Screen

This screen allows you to set a variety of different
preferences: the foot pedal jack's performance, dim
Part VIII–Data Entry, System & File Management
MAIN
SETTINGS/ PREFS
) soft key to scroll to
This parameter is for the
PEAK HOLD TIME
long you want the meters to hold peaks (from 9 ms to
infinity).
AVE COEFFICIENT
first part of meter ballistics – the speed of attack. At
smaller values, the amount of data passing through
the meter is lower than it is at higher values, speeding
up the meter's performance.
BAR DECAY RATE
second part of meter ballistics – the decay rate. The
value refers to the number of db (decibels) the meter
falls every second. The higher the number in db per
second, the faster the meter recedes after a peak.
MIXER MT POINT
Point—that is, the point in the signal chain that is
depicted by the meter. The choices are:
after the A/D conversion),
(post-fader).
MASTER MT POINT
,
metering point for the Master L/R Buss. The choices
are: (pre-buss trim),
Sig
fader).
BUSS MT POINT
metering point for the Busses. The choices are either
pre or post fader.
AUX/CUE MT POINT
metering point for the Cue buss and the Aux Sends.
The choices are pre- or post-fader.
attenuation, and Control Room and Studio Out atten-
uation.
TASCAM SX-1 Reference Manual
Here, you can choose how
This parameter determines the
This control deals with the
This sets the Mixer Metering
(directly
Sig
(pre-fader), and
Pre
This setting determines the
(pre-fader), and
Pre Post
This setting determines the
This setting determines the
183
Post
(post-