Lcd Locate Control; Locate Points; Registers - Tascam SX-1 Reference Manual

Part III–Locate, Transport, & Surround

LCD Locate Control

Direct access locate controls are also available
through the LCD screen.

LOCATE POINTS

On this screen you can manage, create, recall, and
edit your current project's locate points.

REGISTERS

On this screen you can enter values for a variety of
location based settings directly from the keypad.
From the
LCD ACCESS
, then press the soft key next to
TRANSPORT
to recall this screen.
REGISTER
40
TASCAM SX-1 Reference Manual
section, press
From the section, press
LCD ACCESS
, then press the soft key next to
TRANSPORT
to recall this screen. Or, just hit the
POINTS
button on the surface twice, in rapid succession.
Scrolls through the locate points
SELECT ENTRY
in the window.
LOCATE POINTS
Opens the
EDIT TIME
EDIT TIME
the selected locate point's position (its time stamp) to
be changed.
Switches between the different
SMPTE FORMAT
possible timecode displays: SMPTE, hours:minutes:
seconds, bars:beats:ticks, feet:frames, or samples.
END PTS & DURATION
and the Auto Punch fields between endpoint and
OUT
duration (the length of the current selection) displays.
ADJUST IN/FROM & ADJUST OUT/TO
parameter becomes active when the
fields are active. This setting allows
Autopunch Duration
the editing of the / and
In From
For example, this means that while lengthening
Duration, you can decide whether to move the Out
point to the right (further down the timeline), or the
In point to the left (earlier on the timeline)—as one
of them has to move to lengthen a duration.
Moves the cursor between the
SELECT PARAM
different location fields.
Changes the value of the selected
CHANGE FIELD
field.
LOCATE
LOCATE
dialog and allows
Switches the Loop
TO
This
and
Loop
/ points separately.
Out To