Vga Locate Control - Tascam SX-1 Reference Manual

TIME
a time register window on the
LCD screen (pictured left). Enter
a value from the keypad and press
to move the transport to that location.
ENTER
Press the
BBT
bars:beats:ticks register window
on the LCD screen (pictured left).
Enter a value from the Keypad and
press to move the transport to that location.
ENTER

VGA Locate Control

To reach this tab, press the
section to recall the
DISPLAY MODE
Then click once on the
Transport
This window allows you to see and
Locate Point
select locate points associated with your current
project.
This field has two functions. Firstly, it dis-
Time
plays the time stamp of the currently selected (high-
lighted) locate point. Secondly, the selected locate
point's time stamp can be changed by entering a new
time and pressing the
STORE
Turns the Loop function on. With
Loop Enabled
Loop enabled, the SX-1 will play from the
point to the point continuously.
Loop To
Sets the Loop In point. Remember that
Loop From
for this location point, as well as all of the following
time-based points, pressing
the time value. From there you can store that value in
any register (as indicated by the prompt indicators
after you press
CAPTURE
Part III–Locate, Transport, & Surround
Press the key to open
TIME
key to open a
BBT
key in the
TRACK MAIN
screen.
Track
tab.
button.
Loop From
first will grab
CAPTURE
).
LOCATE
to recall saved locate points and
to enable the creation of new
ones. Press the key once and a
locate point register window
appears on the LCD screen (pictured left). Use the
Keypad to enter a stored locate point and press
to move the transport to that location. Press-
ENTER
ing the key twice in rapid succession will bring up
the screen's
TRANSPORT Locate
can be named and managed.
Sets the Loop Out point.
Loop To
Auto Punch Enabled
function on. In this mode, with the transport in
motion and in record, the SX-1 will automatically
punch into the record enabled track when the trans-
port crosses the
Auto Punch In
of record when the transport crosses the
point.
Auto Punch Rehearsal
function in Rehearsal mode. In this mode, the SX-1
will simulate an Auto Punch action (by switching to
Input monitor at the Auto Punch In point and back to
disk playback at the Auto Punch Out point). This
allows you fine-tune your punch points for accuracy
before recording anything.
Sets the Auto Punch In point.
Auto Punch In
Sets the Auto Punch Out point.
Auto Punch Out
TASCAM SX-1 Reference Manual
Use the key
LOCATE
window where points
Turns the Auto Punch
point, and will punch out
Auto Punch Out
Places the Auto Punch
39