Tascam SX-1 Reference Manual page 101

cally, after the specified amount of time has passed
without being pressed. This field can be set from 0.5
seconds to 10 seconds in 0.5 second increments.
Auto Revert Choices
(or Trim) enabled, the automation system stops writ-
ing (or trimming) switch events automatically on a
per control basis without the need to end writing
manually. That is, keys stop recording switch events
at different times, depending on when they were last
pressed and depending on the
value.
1 sec
+12
Switch ON
+6
+3
0
-3
-6
-12
1 sec
+12
+6
+3
0
-3
-6
-9
-12
1 sec
+12
Switch ON
+6
+3
0
-3
-6
-9
-12
With Auto Revert Write
Control Sense Time Out
Existing Switch Events
2 sec 3 sec
4 sec
Switch OFF
New Switch Events
2 sec 3 sec
4 sec
Switch OFF
Resulting Switch Events
2 sec 3 sec 4 sec
Switch OFF
Part IV–Mixer Controls
In the case of control surface keys and knobs, writing
ends when the Control Sense Time Out has expired
without a key press or knob turn. Control Sense Time
Out allows the control surface keys to respond as if
they are touch-sensitive, even though they are not.
Writing switch events over a Static switch position
simply adds the new switch events. When writing
new switch events over previous ones, the SX-1
automation system provides you with a high degree
of flexibility over when writing will end.
Below is an example of writing new switch events
over previous switch events with Auto Revert
enabled:
5 sec 6 sec 7 sec 8 sec
Switch ON
Switch OFF
5 sec 6 sec 7 sec 8 sec
Switch ON
Control
Sense
Timeout
7 sec
5 sec 6 sec 8 sec
Control
Sense
Timeout
TASCAM SX-1 Reference Manual
101