Tascam SX-1 Reference Manual page 93

Enables the automation All Safe mode,
All Safe
where no auto data is generated. See the definition
"Safe" on page 81.
After dynamic automation is already
Init Edit
recorded, check this box to enable changing the ini-
tial value of the automation data. For example, to
change the initial start position of a fader before the
first automation move.
Enables Global Write mode.
Write
Enables Global Trim mode.
Trim
Enables Global Rehearse mode.
Rehearse
Click to revert the most recently moved
Revert All
controllers back to their original values.
Press this button to save the current mix
Keep Mix
within the project and automatically assign it an
incremented numerical designation if a mix of the
same name already exists. This is useful for creating
Mix Milestones for the ability to go back to an earlier
point in the mixing process. All mixes are stamped
with their date and time of creation for easy refer-
ence.
Click to begin an auto-fade on the Master
Fade
fader. The system must be in Global Write or Trim to
do this.
Enables auto-revert during
Write Auto-Revert
Write automation. Auto Revert causes any controls
currently Writing or Trimming to exit Write/Trim
and transition back to the setting they held prior to
the Write or Trim operation. The amount of time
taken for this transition is determined by the setting
of the Write Revert Time parameter.
Determines the amount of
Write Revert Time
time it takes, after the control is released, for a Write
move to return to its original value.
Write To End (for Write mode):
when this box is checked, the last value of the control
during an automation pass will be written to the end
of the project, overwriting any data already there.
This operates independently of the setting of Auto
Revert.
Trim Auto-Revert
Trim automation. Auto Revert causes any controls
currently Writing or Trimming to exit Write/Trim
and transition back to the setting they held prior to
the Write or Trim operation. The amount of time
taken for this transition is determined by the setting
of the Trim Revert Time parameter.
Trim Revert Time
it takes, after the control is released, for a Trim move
to return to the track's original value (see the Before
and After Trim diagrams).
Trim To End (for Trim Mode):
this box is checked, the last Trim value of the control
during an automation pass will be written to the end
of the project. This operates independently of the set-
ting of Auto Revert.
Control Sense Timeout
touch-sensitive controls, revert starts when the
CONTROL SENSE TIMEOUT
ment of the control. This feature allows controls to
respond as if they were touch-sensitive even though
they are not.
Control Sense Time
Control Sense Timeout
Initial Event Ramp Time
mines the transition time between a new Initial Status
and previous Dynamic data when editing the initial
status; very much like a time-reversed version of
Revert Time.
Auto Fade Time
Fade from 0.5s to 120s in 0.1 second increments.
Library Transition Time
takes for controllers to move from their current state
to the new settings of a just recalled library preset.
Event Density
recorded during automation, and adjustable in single-
Infinite—
frame increments from 1 through 30. The more
events that are used to describe a move, the smoother
the move is.
Part IV–Mixer Controls
Enables auto-revert during
Determines the amount of time
Infinite—when
In the case of non
has expired without move-
Adjusts the time for the
.
This parameter deter-
Sets the duration of an Auto
The amount of time it
Determines the events per second
TASCAM SX-1 Reference Manual
93