Table of Contents
Advertisement
6 - Basic Recording
NOTE
• "Q" refers to the center frequency of the equalizer divided by
the bandwidth. A high Q value reduces the cut and/or boost
applied to the frequencies. Depending on the equalizer
setting, the graph at the top of the screen changes.
• If you press the F1 (
EQ FLAT
on the open Mixer screen will be restored to their default
values.
4. After making the settings, press the HOME button to return
to the Home screen.
DIGITAL TRIM setting (Track only)
Depending on the playback sound, EQ boosting could cause
distortion (digital clipping). If this happens, use the DIGITAL
TRIM to lower the playback level before the EQ.
1. Use the CURSOR (5/b/g/t) buttons to move the cursor
to the
DIGITAL TRIM
DIGITAL TRIM indication
2. Turn the JOG/DATA dial to set the value.
Setting range:
to
-42dB
Sending signals to internal/external effects
This unit has two external effect send systems (EFF 1 and EFF 2)
and a send for the internal effects (INSERT EFFECT).
You can adjust send levels for each track. For details about the
built-in send effects, see "Send effects" on page 54.
1. Use the CURSOR (5/b/g/t) buttons to move the cursor
to the
SEND EFF 1/EFF 2
2. Turn the JOG/DATA dial to enable the effect.
Options:
(default),
OFF
PRE
PRE
This sends the track pre-fader signal to the effect send
bus. The effect send signal level is not affected by the
track fader.
POST
This sends the track post-fader signal to the effect send
bus. The effect send signal level is affected by the track
fader.
3. Use the SEND EFF 1/EFF 2 knobs to adjust the external
send levels.
Setting range:
to
(Default:
0
127
4. Use the SEND MASTER 1/MASTER 2 to adjust the send
master level.
Setting range:
to
(Default:
0
127
38
TASCAM DP-24SD
) button, all the settings
display area.
(Default:
)
+6dB
0dB
area.
Effect send indication
,
POST
)
0
)
0
Enabling insert effects
This unit has dynamic and guitar effects that can be used as
insert effects.
1. Use the CURSOR (5/b/g/t) buttons to move the cursor
to the
INSERT EFFECT
INSERT EFFECT indicator
2. Turn the JOG/DATA dial to set the insert effect.
Options:
OFF:
INSERT EFFECT
ON:
INSERT EFFECT
Setting the stereo position
Use the PAN parameter to set the stereo position.
The full left value is
, and the full right value is
L63
center position is shown by
.
C
PAN indication
Turn the PAN knob to adjust the stereo position.
Setting range:
to
to
L63
C
R63
Changing the signal phase
When the phase is inverted due to the mic wiring or other reason,
use the
Ø display area to correct the phase.
PHASE
1. Use the CURSOR (5/b/g/t) buttons to move the cursor
to the
Ø display area.
PHASE
Phase
2. Turn the JOG/DATA dial to change the built-in signal phase.
Options:
Ø indicator unlit (default): Normal phase
PHASE
Ø indicator lit: Inverted phase
PHASE
display area.
indicator unlit (default)
indicator lit
. The
R63
(Default:
)
C
Advertisement
Table of Contents
