Table of Contents
Advertisement
Note:
It is strongly recommended that the LAN ports on the front of the G150
Note:
(configured via LAN1 on Manager's System configuration form) are used to
connect local IP phones and the G150 operates as the IP phones' DHCP server.
Installing the Manager Software
Before any aspects of the G150 can be configured, a configuration software application called
Manager must be installed on the PC that is connected to the G150. The Manager software is
available from the Administrator CD.
With the initial assembly completed and your PC connected to the G150, do the following to
install the Manager software:
1. Insert the Administrator CD into the PC's CD drive. The CD autoruns. You are initially
presented with the option to select which language you wish to use. Select the language
from the pull down list and click OK.
2. The InstallShield Wizard for the G150 Admin Suite is started. Click Next.
3. The Destination folder location option menu is displayed. Either accept the default location
of where the Administration Suite is to be installed (click Next) or change the location by
clicking Browse and entering a new location.
4. Select the following components to be installed:
System Monitor: Application for tracking the G150 Media Gateway system's
performance.
Manager: Application for configuring the G150 Media Gateway.
5. Deselect the other components.
6. Click Next.
7. Name the program folder or accept the default (G150), click Next and wait for the
Administration Suite installation to be completed. This can take several minutes.
8. Installation runs and on completion, select Finish. No reboot is necessary after the
installation of this software application.
The Manager configuration tool is installed on your PC and you are now ready to configure the
G150.
The Manager Application Software
Issue 1 June 2005
89
Advertisement
Table of Contents
