NETGEAR ProSAFE SRX5308 Reference Manual page 262

ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
Figure 171.
3. Specify the settings that are described in the following table.
Table 63. VPN client IPSec configuration settings (Mode Config)
Setting Description
VPN Client This field is masked out because Mode Config is selected. After an IPSec connection is
address established, the IP address that is issued by the VPN firewall displays in this field (see
Figure 176
Address Type Select Subnet address from the drop-down list.
Remote host The address that you need to enter depends on whether you have specified a LAN IP
address network address in the Local IP Address field on the Add Mode Config Record screen of
the VPN firewall:
•
•
Subnet mask Enter 255.255.255.0 as the remote subnet mask of the VPN firewall that opens the VPN
tunnel. This is the LAN IP subnet mask that you specified in the Local Subnet Mask field
on the Add Mode Config Record screen of the VPN firewall. If you left the Local Subnet
Mask field blank, enter the VPN firewall's default IP subnet mask.
Virtual Private Networking Using IPSec and L2TP Connections
on page 266).
If you left the Local IP Address field blank, enter the VPN firewall's default LAN IP
address as the remote host address that opens the VPN tunnel. For example, enter
192.168.1.1.
If you specified a LAN IP network address in the Local IP Address field, enter the
address that you specified as the remote host address that opens the VPN tunnel.
262