Figure - NETGEAR ProSAFE SRX5308 Reference Manual

To change an existing outbound or inbound service rule, in the Action column to the right of
the rule, click one of the following table buttons:
• Up. Moves the rule up one position in the table rank.
• Down. Moves the rule down one position in the table rank.
• Edit. Lets you change the definition of an existing rule. Depending on your selection, one
of the following screens displays:
- Edit LAN WAN Outbound Service screen for IPv4 (identical to
- Edit LAN WAN Inbound Service screen for IPv4 (identical to

To change the default outbound policy for IPv6 traffic or to change existing IPv6 rules:
1. Select Security > Firewall. The Firewall submenu tabs display with the LAN WAN
Rules screen for IPv4 in view.
2. In the upper right of the screen, select the IPv6 radio button. The LAN WAN Rules screen
displays the IPv6 settings. (The following figure contains examples.)

Figure 76.

3. From the Default Outbound Policy drop-down list, select Block Always. (By default, Allow
Always is selected.)
4. Next to the drop-down list, click the Apply table button.
To change an existing outbound or inbound service rule, in the Action column to the right of
the rule, click one of the following table buttons:
• Up. Moves the rule up one position in the table rank.
• Down. Moves the rule down one position in the table rank.
• Edit. Lets you change the definition of an existing rule. Depending on your selection, one
of the following screens displays:
- Edit LAN WAN Outbound Service screen for IPv6 (identical to
- Edit LAN WAN Inbound Service screen for IPv6 (identical to
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
Firewall Protection
146
Figure 77 on page 148)
Figure 79 on page 150)
Figure 78 on page 149)
Figure 80 on page 151)