NETGEAR ProSAFE SRX5308 Reference Manual page 315

6. In the Add Defined Addresses section of the screen, add an address to the Defined
Addresses table by entering the settings as described in the following table:
Table 79. Defined addresses settings for IPv4
Setting
Source Address Type Select the type of address from the drop-down list:
Network Address / IP
Address
Mask Length
7. Click the Add table button. The address is added to the Defined Addresses table.
8. Repeat Step 6
Addresses table.

To delete one or more IPv4 addresses:
1. In the Defined Addresses table, select the check box to the left of each address that you
want to delete, or click the Select All table button to select all addresses.
2. Click the Delete table button.
Configure Login Restrictions Based on IPv6 Addresses

To restrict logging in based on IPv6 addresses:
1. Select Users > Users. The Users screen displays (see
2. In the Action column of the List of Users table, click the Policies table button for the user for
which you want to set login policies. The policies submenu tabs display, with the Login
Policies screen in view.
3. Click the By Source IP Address submenu tab.
4. In the upper right of the screen, select the IPv6 radio button. The By Source IP Address
screen displays the IPv6 settings. (The following figure shows an IP address in the Defined
Addresses table as an example.)
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
Description
• IP Address. A single IPv4 address.
• IP Network. A subnet of IPv4 addresses. You need to enter a netmask length
in the Mask Length field.
Depending on your selection from the Source Address Type drop-down list, enter
the IP address or the network address.
For a network address, enter the netmask length (0–32).
Note: By default, a single IPv4 address is assigned a netmask length of 32.
and Step 7 for any other addresses that you want to add to the Defined
Manage Users, Authentication, and VPN Certificates
Figure 205
315
on page 311).