NETGEAR ProSAFE SRX5308 Reference Manual page 402

ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
Figure 261.
b. In the Backup / Restore Settings section of the screen, click the Default button.
The VPN firewall reboots. During the reboot process, the Settings Backup and Firmware
Upgrade screen might remain visible, or a status message with a counter might show the
number of seconds left until the reboot process is complete. The reboot process takes
about 160 seconds. (If you can see the unit: The reboot process is complete when the
Test LED on the front panel goes off.)
WARNING:
When you press the hardware factory default Reset button or click
the software Default button, the VPN firewall settings are erased.
All firewall rules, VPN policies, LAN and WAN settings, and other
settings are lost. Back up your settings if you intend on using
them.
Note: After you reboot with factory default settings, the VPN firewall's
password is password, and the LAN IPv4 address is 192.168.1.1.
Troubleshooting
402