NETGEAR ProSAFE SRX5308 Reference Manual page 81

ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
Table 15. Add QoS screen settings for a priority profile (continued)
Setting
Service
Direction
Diffserv QoS Match
Priority
Hosts
Start IP
End IP
Select Group
Bandwidth Allocation
Outbound Minimum
Bandwidth
Outbound Maximum
Bandwidth
Inbound Minimum
Bandwidth
Inbound Maximum
Bandwidth
Diffserv QoS Remark
4. Click Apply to save your settings. The profile is added to the List of QoS Profiles table on
the QoS screen.
Description
From the drop-down list, select a service or application to be covered by this
profile. If the service or application does not appear in the list, you need to
define it using the Services screen (see
page 177).
From the drop-down list, select the direction to which the priority queue is
applied:
• Outbound Traffic. The priority queue is applied to outbound traffic only.
• Inbound Traffic. The priority queue is applied to inbound traffic only.
Enter a DSCP value in the range of 0 through 63. Packets are classified against
this value. Leave this field blank to disable packet matching.
From the drop-down list, select the priority queue that determines the allocation
of bandwidth:
• Low. All services that are assigned a low-priority queue share 10 percent
of interface bandwidth.
• High. All services that are assigned a high-priority queue share 60 percent
of interface bandwidth.
Note: By default, all services are assigned the medium-priority queue in which
they share 30 percent of the interface bandwidth.
These settings do not apply to a priority profile.
Enter a DSCP value in the range of 0 through 63. Packets are marked with this
value. Leave this field blank to disable packet marking.
IPv4 and IPv6 Internet and WAN Settings
81
Add Customized Services on