NETGEAR ProSAFE SRX5308 Reference Manual page 57

ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
6. As an optional step: If you have selected the Stateless Address Auto Configuration radio
button, you can select the Prefix Delegation check box:
• Prefix delegation check box is selected. A prefix is assigned by the ISP's stateful
DHCPv6 server through prefix delegation, for example, 2001:db8:: /64. The VPN
firewall's own stateless DHCPv6 server can assign this prefix to its IPv6 LAN clients.
For more information about prefix delegation, see
Prefix Delegation
• Prefix delegation check box is cleared. Prefix delegation is disabled. This is the
default setting.
7. Click Apply to save your changes.
8. Verify the connection:
a. Select Network Configuration > WAN Settings > WAN Setup.
b. In the upper right of the screen, select the IPv6 radio button. The WAN Setup screen
displays the IPv6 settings (see
c. In the Action column, click the Status button of the WAN interface for which you
want to display the Connection Status pop-up screen. (The following figure shows a
dynamic IP address configuration.)
Figure 31.
The Connection Status screen should show a valid IP address and gateway, and you are
connected to the Internet. If the configuration was not successful, see
ISP Connection on page 396.
Note: For more information about the Connection Status screen, see
the WAN Port Status
on page 103.
Figure 29
on page 382.
IPv4 and IPv6 Internet and WAN Settings
57
Stateless DHCPv6 Server With
on page 55).
Troubleshoot the
View