Manage Static Ipv4 Routing; Configure Static Ipv4 Routes - NETGEAR ProSAFE SRX5308 Reference Manual

3. Click Apply to save your settings.

To delete one or more advertisement prefixes:
1. On the RADVD screen for the DMZ screen (see
check box to the left of each advertisement prefix that you want to delete, or click the
Select All table button to select all advertisement prefixes.
2. Click the Delete table button.

Manage Static IPv4 Routing

•

Configure Static IPv4 Routes

• Configure the Routing Information Protocol
• IPv4 Static Route Example
Static routes provide additional routing information to your VPN firewall. Under normal
circumstances, the VPN firewall has adequate routing information after it has been
configured for Internet access, and you do not need to configure additional static routes. You
should configure static routes only for unusual cases such as multiple firewalls or multiple IP
subnets on your network.
Note: The VPN firewall automatically sets up routes between VLANs and
secondary IPv4 addresses that you have configured on the LAN
Multi-homing (IPv4) screen (see
Addresses on the Default VLAN
need to manually add an IPv4 static route between a VLAN and a
secondary IPv4 address.
Configure Static IPv4 Routes

To add an IPv4 static route to the Static Route table:
1. Select Network Configuration > Routing. In the upper right of the screen, the IPv4
radio button is selected by default. The Static Routing screen displays the IPv4 settings.
(The following figure contains one example.)
Figure 69.
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
LAN Configuration
Figure 67 on page 124), select the
Configure IPv4 Multihome LAN IP
on page 94). Therefore, you do not
127