Enable Source Mac Filtering - NETGEAR ProSAFE SRX5308 Reference Manual


To set a schedule:
1. Select Security > Services > Schedule 1. The Schedule 1 screen displays:
Figure 114.
2. In the Scheduled Days section, select one of the following radio buttons:
• All Days. The schedule is in effect all days of the week.
• Specific Days. The schedule is in effect only on specific days. To the right of the radio
buttons, select the check box for each day that you want the schedule to be in effect.
3. In the Scheduled Time of Day section, select one of the following radio buttons:
• All Day. The schedule is in effect all hours of the selected day or days.
• Specific Times. The schedule is in effect only during specific hours of the selected
day or days. To the right of the radio buttons, fill in the Start Time and End Time fields
(Hour, Minute, AM/PM) during which the schedule is in effect.
4. Click Apply to save your settings to Schedule 1.
Repeat these steps to set to a schedule for Schedule 2 and Schedule 3.

Enable Source MAC Filtering

The Source MAC Filter screen enables you to permit or block traffic coming from certain
known computers or devices.
By default, the source MAC address filter is disabled. All the traffic received from computers
with any MAC address is allowed. When the source MAC address filter is enabled,
depending on the selected policy, traffic is either permitted or blocked if it comes from any
computers or devices whose MAC addresses are listed in MAC Addresses table.
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
Firewall Protection
190