Modify Or Delete A Mode Config Record; Configure Keep-Alives And Dead Peer Detection - NETGEAR ProSAFE SRX5308 Reference Manual

2. Verify that the VPN firewall issued an IP address to the VPN client. This IP address
displays in the VPN Client address field on the IPSec pane of the VPN client. (The
following figure shows the upper part of the IPSec pane only.)
Figure 175.
3. From the client computer, ping a computer on the VPN firewall LAN.

Modify or Delete a Mode Config Record

Note: Before you modify or delete a Mode Config record, make sure that it
is not used in an IKE policy.

To edit a Mode Config record:
1. On the Mode Config screen (see
Action column for the record that you want to modify. The Edit Mode Config Record
screen displays. This screen is identical to the Add Mode Config Record screen (see
Figure 165 on page 251).
2. Modify the settings as described in
3. Click Apply to save your settings.

To delete one or more Mode Config records:
1. On the Mode Config screen (see
left of each record that you want to delete, or click the Select All table button to select
all records.
2. Click the Delete table button.

Configure Keep-Alives and Dead Peer Detection

• Configure Keep-Alives
• Configure Dead Peer Detection
In some cases, you might not want a VPN tunnel to be disconnected when traffic is idle, for
example, when client-server applications over the tunnel cannot tolerate the tunnel
establishment time. If you require a VPN tunnel to remain connected, you can use the
Virtual Private Networking Using IPSec and L2TP Connections
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
Figure 164
Table 59
Figure 164
on page 251), click the Edit button in the
on page 252.
on page 251), select the check box to the
265