Manually Configure An Ipv4 Internet Connection - NETGEAR ProSAFE SRX5308 Reference Manual

Figure 13.
The Connection Status screen should show a valid IP address and gateway, and you are
connected to the Internet. If the configuration was not successful, skip ahead to
Configure an IPv4 Internet Connection
Connection on page 396.
Note: For more information about the Connection Status screen, see
the WAN Port Status

Manually Configure an IPv4 Internet Connection

Unless your ISP automatically assigns your configuration through a DHCP server, you need
to obtain configuration parameters from your ISP to manually establish an Internet
connection. The required parameters for various connection types are listed in
page 33.

To manually configure the WAN IPv4 ISP settings:
1. Select Network Configuration > WAN Settings > WAN Setup. In the upper right of the
screen, the IPv4 radio button is selected by default. The WAN Setup screen displays the
IPv4 settings:
Figure 14.
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
on page 382.
IPv4 and IPv6 Internet and WAN Settings
on page 34, or see Troubleshoot the ISP
34
Manually
View
Table 2 on