NETGEAR ProSAFE SRX5308 Reference Manual page 66


To configure an ISATAP tunnel:
1. Select Network Configuration > WAN Settings > ISATAP Tunnels. The ISATAP
Tunnels screen displays. (The following figure shows some examples.)
Figure 38.
2. Click the Add table button under the List of Available ISATAP Tunnels table. The Add
ISATAP Tunnel screen displays:
Figure 39.
3. Specify the tunnel settings as described in the following table.
Table 11. Add ISATAP Tunnel screen settings
Setting
ISATAP Subnet Prefix
Local End Point
Address
IPv4 Address
4. Click Apply to save your changes.
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
Description
The IPv6 prefix for the tunnel.
From the drop-down list, select the type of local address:
• LAN. The local endpoint address is the address of the default VLAN.
• Other IP. The local endpoint address is another LAN IP address that you
need to specify in the IPv4 Address fields.
If you select Other IP from the Local End Point Address drop-down list, enter the
IPv4 address.
IPv4 and IPv6 Internet and WAN Settings
66