NETGEAR ProSAFE SRX5308 Reference Manual page 143

ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
Table 34. Inbound rules overview (continued)
Setting Description
WAN Users The settings that determine which Internet locations are covered
by the rule, based on their IP address. The options are:
•
•
•
•
DMZ Users The settings that determine which DMZ computers on the DMZ
network are affected by this rule. The options are:
•
•
•
Note:
apply when the WAN mode is NAT because your network
presents only one IP address to the Internet.
QoS Profile The priority assigned to IP packets of this service. The priorities
are defined by Type of Service in the Internet Protocol Suite
standards, RFC 1349. The QoS profile determines the priority of
a service, which, in turn, determines the quality of that service for
the traffic passing through the firewall.
The VPN firewall marks the Type of Service (ToS) field as
defined in the QoS profiles that you create. For more information,
see
page 184.
Note:
After you have created a QoS profile, it can become active only
when you apply it to a nonblocking inbound or outbound firewall
rule.
Note:
Log The setting that determines whether packets covered by this rule
are logged. The options are:
•
•
Any. All Internet IP addresses are covered by this rule.
Single address. Enter the required address in the Start
field.
Address range. Enter the required addresses in the Start
and Finish fields.
IP Group. Select the IP group to which the rule applies. Use
the IP Groups screen to assign IP addresses to groups. See
Create IP Groups on page 179.
Any. All computers and devices on your DMZ network.
Single address. Enter the required address in the Start field
to apply the rule to a single computer on the DMZ network.
Address range. Enter the required addresses in the Start
and Finish fields to apply the rule to a range of DMZ
computers.
For IPv4 DMZ WAN inbound rules, this field does not
Create Quality of Service Profiles for IPv4 Firewall Rules
There are no default QoS profiles on the VPN firewall.
QoS profiles do not apply to LAN DMZ rules.
Always. Always log traffic that matches this rule. This is
useful when you are debugging your rules.
Never. Never log traffic that matches this rule.
Firewall Protection
143
Inbound Rules
LAN WAN rules
DMZ WAN rules
DMZ WAN rules
LAN DMZ rules
IPv4 LAN WAN rules
IPv4 DMZ WAN rules
on
All rules