Roadmap To Setting Up Ipv6 Internet Connections To Your Isps - NETGEAR ProSAFE SRX5308 Reference Manual

5. (Optional) Configure Dynamic DNS on the WAN interfaces. If necessary, configure your
fully qualified domain names.
This task is described in
6. (Optional) Configure the WAN options. If necessary, change the factory default MTU size,
port speed, and MAC address of the VPN firewall. These are advanced features, and you
usually do not need to change the settings.
This task is described in
7. (Optional) Configure the WAN traffic meters.
This task is described in
Roadmap to Setting Up IPv6 Internet Connections to Your
ISPs
Setting up IPv6 Internet connections to your ISP or ISPs includes six tasks, four of which are
optional.

Complete these tasks:
1. Configure the IPv6 routing mode. Configure the VPN firewall to support both devices
with IPv4 addresses and devices with IPv6 addresses.
This task is described in
2. Configure the IPv6 Internet connections to your ISPs. Connect to an ISP by configuring
a WAN interface.
You have three configuration options. These tasks are described in the following sections:
• Use a DHCPv6 Server to Configure an IPv6 Internet Connection
• Configure a Static IPv6 Internet Connection
• Configure a PPPoE IPv6 Internet Connection
3. (Optional) Configure the IPv6 tunnels. Enable 6to4 tunnels and configure ISATAP tunnels.
These tasks are described in the following sections:
• Configure 6to4 Automatic Tunneling
• Configure ISATAP Automatic Tunneling
4. (Optional) Configure Stateless IP/ICMP Translation (SIIT). Enable IPv6 devices that do
not have permanently assigned IPv4 addresses to communicate with IPv4-only devices.
This task is described in
5. (Optional) Configure auto-rollover. By default, the WAN interfaces are configured for
primary (single) WAN mode. You can enable auto-rollover and configure the failure detection
settings.
These tasks are described in
ProSAFE Gigabit Quad WAN SSL VPN Firewall SRX5308
Configure Dynamic DNS
Configure Advanced WAN Options and Other Tasks
Configure and Enable the WAN Traffic Meter
Configure the IPv6 Routing Mode
Configure Stateless IP/ICMP Translation
Configure Auto-Rollover for IPv6 Interfaces
IPv4 and IPv6 Internet and WAN Settings
on page 49.
on page 53.
on page 58
on page 61
on page 64
on page 65
28
on page 71.
on page 356.
on page 55
on page 67.
on page 68.