Configuring Fspf Link Cost; About Hello Time Intervals; Configuring Hello Time Intervals; About Dead Time Intervals - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Configuring FSPF Link Cost

Configuring FSPF Link Cost
To configure FSPF link cost, perform this task:
Procedure
Step 1
Step 2
Step 3

About Hello Time Intervals

You can set the FSPF Hello time interval to specify the interval between the periodic hello messages sent to
verify the health of the link. The integer value can range from 1 to 65,535 seconds.
Note This value must be the same in the ports at both ends of the ISL.

Configuring Hello Time Intervals

To configure the FSPF Hello time interval, perform this task:
Procedure
Step 1
Step 2
Step 3

About Dead Time Intervals

You can set the FSPF dead time interval to specify the maximum interval for which a hello message must be
received before the neighbor is considered lost and removed from the database. The integer value can range
from 1 to 65,535 seconds.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
582
Command or Action
switch# configuration terminal
switch(config)# interface fc slot/port
switch(config-if)# fspf cost value vsan
vsan-id
Command or Action
switch# configuration terminal
switch(config)# interface fc slot/port
switch(config-if)# fspf hello-interval
value vsan vsan-id
Configuring Fibre Channel Routing Services and Protocols
Purpose
Enters configuration mode.
Configures the specified interface, or if already
configured, enters configuration mode for the
specified interface.
Configures the cost for the selected interface in the
specified VSAN.
Purpose
Enters configuration mode.
Configures the specified interface, or if already
configured, enters configuration mode for the
specified interface.
Specifies the hello message interval to verify the
health of the link in VSAN 175. The default is 20
seconds.
OL-16597-01