Assigning Static Port Vsan Membership; Displaying Vsan Static Membership - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Configuring and Managing VSANs
• Dynamically—Assigning VSANs based on the device WWN. This method is referred to as dynamic
VSAN trunking ports have an associated list of VSANs that are part of an allowed list.
Related Topics
•
•

Assigning Static Port VSAN Membership

To statically assign VSAN membership for an interface port, perform this task:
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6

Displaying VSAN Static Membership

To display the VSAN static membership information, use the show vsan membership command.
The following example displays membership information for the specified VSAN:
switch # show vsan 1 membership
vsan 1 interfaces:
Interface information is not displayed if interfaces are not configured on this VSAN.
Note
The following example displays membership information for all VSANs:
switch # show vsan membership
vsan 1 interfaces:
OL-16597-01
port VSAN membership (DPVM). Cisco Nexus 5000 Series switches do not support DPVM.
Assigning Static Port VSAN Membership, page 537
Configuring VSAN Trunking, page 507
Command or Action
switch# configuration terminal
switch(config)# vsan database
switch(config-vsan-db)# vsan vsan-id
switch(config-vsan-db)# vsan vsan-id
interface {fc slot/port | vfc vfc-id}
switch(config-vsan-db)# vsan vsan-id {fc
slot/port | vfc vfc-id}
switch(config-vsan-db)# no vsan vsan-id {fc
slot/port | vfc vfc-id}
fc2/1 fc2/2 fc2/3
san-port-channel 3
fc2/1 fc2/2 fc2/3
fc2/4
vfc1/1
fc2/4
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Assigning Static Port VSAN Membership
Purpose
Enters configuration mode.
Configures the database for a VSAN.
Creates a VSAN with the specified ID if that
VSAN does not exist already.
Assigns the membership of the specified
interface to the VSAN.
Updates the membership information of the
interface to reflect the changed VSAN.
Removes the interface from the VSAN.
537