Verifying Etherchannel Configuration - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Configuring the LACP Port Priority
Step 2
Step 3
This example shows how to set the LACP port priority for Ethernet interface 1/4 to 40000:
switch# configure terminal
switch (config)# interface ethernet 1/4
switch(config-if)# lacp port priority 40000

Verifying EtherChannel Configuration

To display EtherChannel configuration information, perform one of the following tasks:
Command
switch# show interface port-channel
channel-number
switch# show feature
switch# show resource
switch# show lacp {counters | interface type
slot/port | neighbor | port-channel |
system-identifier}
switch# show port-channel
compatibility-parameters
switch# show port-channel database [interface
port-channel channel-number]
switch# show port-channel summary
switch# show port-channel traffic
switch# show port-channel usage
switch# show port-channel database
switch# show port-channel load-balance
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
122
Command or Action
switch(config)# interface type
slot/port
switch(config-if)# lacp port-priority
priority
Verifying EtherChannel Configuration
Purpose
Specifies the interface to configure, and enters the
interface configuration mode.
Configures the port priority for use with LACP. Valid
values are 1 through 65535, and higher numbers have
lower priority. The default value is 32768.
Purpose
Displays the status of a EtherChannel interface.
Displays enabled features.
Displays the number of resources currently available
in the system.
Displays LACP information.
Displays the parameters that must be the same among
the member ports in order to join an EtherChannel.
Displays the aggregation state for one or more
port-channel interfaces.
Displays a summary for the EtherChannel interfaces.
Displays the traffic statistics for EtherChannels.
Displays the range of used and unused channel
numbers.
Displays information on current running of the
EtherChannel feature.
Displays information about load-balancing using
EtherChannels.
OL-16597-01