Verifying Ip Acl Configurations; Displaying And Clearing Ip Acl Statistics - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Verifying IP ACL Configurations

Some configuration parameters when applied to an EtherChannel are not reflected on the configuration
Note
of the member ports.
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Verifying IP ACL Configurations
To display IP ACL configuration information, perform one of the following tasks:
Procedure
Step 1
Step 2
For detailed information about the fields in the output from these commands, refer to the Cisco Nexus 5000
Series Command Reference.

Displaying and Clearing IP ACL Statistics

Use the show ip access-lists and show ipv6 access-list commands to display statistics about an IP ACL,
including the number of packets that have matched each rule. For detailed information about the fields in the
output from this command, refer to the Cisco Nexus 5000 Series Command Reference.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
286
Command or Action
switch# configure terminal
switch(config)# interface {ethernet
[chassis/]slot/port | port-channel
channel-number}
switch(config-if)# {ip port access-group |
ipv6 port traffic-filter} access-list in
switch# show running-config
switch# copy running-config
startup-config
Command or Action
switch# show running-config
switch# show running-config
interface
Purpose
Enters configuration mode.
Enters interface configuration mode for the
specified interface.
Applies an IPv4 or IPv6 ACL to the interface or
EtherChannel. Only inbound filtering is supported
with port ACLs. You can apply one port ACL to
an interface.
(Optional)
Displays ACL configuration.
(Optional)
Copies the running configuration to the startup
configuration.
Purpose
Displays ACL configuration, including IP ACL
configuration and interfaces that IP ACLs are applied
to.
Displays the configuration of an interface to which you
have applied an ACL.
Configuring IP ACLs
OL-16597-01