Verifying Online Diagnostics Configuration; Configuring Online Diagnostics; Default Gold Settings - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Expansion Module Diagnostics

Configuring Online Diagnostics

You can configure the bootup diagnostics to run the complete set of tests, or you can bypass all bootup
diagnostic tests for a faster module boot up time.
Note We recommend that you set the bootup online diagnostics level to complete. We do not recommend
bypassing the bootup online diagnostics.
Procedure
Step 1
Step 2
Step 3
The following example shows how to configure the bootup diagnostics level to trigger the complete diagnostics:
switch# configure terminal
switch(config)# diagnostic bootup level complete

Verifying Online Diagnostics Configuration

To display online diagnostics configuration information, perform one of the following tasks:
Command
show diagnostic bootup level
show diagnostic result module slot

Default GOLD Settings

The following table lists the default settings for online diagnostics parameters.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
332
Command or Action
switch# configure terminal
switch(config)# diagnostic bootup
level [complete | bypass]
switch# show diagnostic bootup
level
Purpose
Enters configuration mode.
Configures the bootup diagnostic level to trigger
diagnostics when the device boots, as follows:
• complete—Performs all bootup diagnostics. This is
the default value.
• bypass—Does not perform any bootup diagnostics.
(Optional)
Displays the bootup diagnostic level (bypass or complete)
that is currently in place on the switch.
Purpose
Displays the bootup diagnostics level.
Displays the results of the diagnostics tests.
Configuring Online Diagnostics
OL-16597-01