Configuring An Allowed-Active List Of Vsans - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Configuring an Allowed-Active List of VSANs

Consequently, VSAN 2 can only be routed from switch 1 through switch 3 to switch 2.
Figure 52: Operational and Allowed VSAN Configuration
Configuring an Allowed-Active List of VSANs
To configure an allowed-active list of VSANs for an interface, perform this task:
Procedure
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
512
Command or Action
switch# configuration terminal
switch(config)# interface fc slot/port
switch(config-if)# switchport trunk allowed vsan
vsan-id - vsan-id
switch(config-if)# switchport trunk allowed vsan
add vsan-id
switch(config-if)# no switchport trunk allowed
vsan vsan-id - vsan-id
switch(config-if)# no switchport trunk allowed
vsan add vsan-id
Configuring VSAN Trunking
Purpose
Enters configuration mode.
Configures the specified interface.
Changes the allowed list for the specified
VSAN range.
Expands the specified VSAN to the new
allowed list.
Deletes the specified VSAN range.
Deletes the expanded allowed list.
OL-16597-01