Vpc Default Settings - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Single Homed Fabric Extender vPC Configuration Example
Step 7 Configure a vPC server port on on the Fabric Extender NX-2000-100.
NX-5000-1(config-if)# interface ethernet 100/1/1
NX-5000-1(config-if)# switchport mode trunk
NX-5000-1(config-if)# switchport trunk native vlan 100
NX-5000-1(config-if)# switchport trunk allowed vlan 100-105
NX-5000-1(config-if)# channel-group 600
NX-5000-1(config-if)# no shutdown
NX-5000-1(config-if)# exit
NX-5000-1(config)# interface port-channel 600
NX-5000-1(config-if)# vpc 600
NX-5000-1(config-if)# no shutdown
NX-5000-1(config-if)# exit
Step 8 Save the configuration.
NX-5000-1(config)# copy running-config startup-config

vPC Default Settings

The following table lists the default settings for vPC parameters.
Table 13: Default vPC Parameters
Parameters
vPC system priority
vPC peer-keepalive message
vPC peer-keepalive interval
vPC peer-keepalive timeout
vPC peer-keepalive UDP port
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
148
Default
32667
Disabled
1 second
5 seconds
3200
vPC Default Settings
OL-16597-01