Verifying Interface Configuration - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Verifying Interface Configuration

The following example shows how to enable 802.1Q tagging on the switch:
switch# configure terminal
switch(config)# vlan dot1q tag native
switch(config)# exit
switch# show vlan dot1q tag native
vlan dot1q native tag is enabled
Verifying Interface Configuration
To display access and trunk interface configuration information, perform one of these tasks:
Command
switch# show interface
switch# show interface switchport
switch# show interface brief
OL-16597-01
Purpose
Displays the interface configuration
Displays information for all Ethernet interfaces,
including access and trunk interfaces.
Displays interface configuration information.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Configuring Native 802.1Q VLANs
109