Configuring Session Manager; Information About Session Manager; Configuration Guidelines And Limitations - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Cli software configuration guide

Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:

Table of Contents

Configuring Session Manager

This chapter contains the following sections:

Configuring Session Manager

This section describes how to configure the Session Manager features in Cisco NX-OS.

Session Manager allows you to implement your configuration changes in batch mode. Session Manager works

in the following phases:

• Configuration session—Creates a list of commands that you want to implement in session manager

• Validation—Provides a basic semantic check on your configuration. Cisco NX-OS returns an error if

• Verification—Verifies the configuration as a whole, based on the existing hardware and software

• Commit— Cisco NX-OS verifies the complete configuration and implements the changes atomically

• Abort—Discards the configuration changes before implementation.

You can optionally end a configuration session without committing the changes. You can also save a

configuration session.

Session Manager has the following configuration guidelines and limitations:

• Session Manager supports only the ACL feature.

• You can create up to 32 configuration sessions.

Configuring Session Manager, page 325

the semantic check fails on any part of the configuration.

configuration and resources. Cisco NX-OS returns an error if the configuration does not pass this

verification phase.

to the device. If a failure occurs, Cisco NX-OS reverts to the original configuration.

C H A P T E R

Cisco Nexus 5000 Series Switch CLI Software Configuration Guide

Table of Contents