Testing Call Home Communications - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Configuring Smart Call Home
Command
switch(config-callhome)# enable
You can disable Call Home in the callhome configuration mode.
Command
switch(config-callhome)# no enable
You can enable Call Home distribution using CFS in the callhome configuration mode.
Command
switch(config-callhome)# distribute
You can commit Call Home configuration changes and distribute using CFS in the callhome configuration
mode.
Command
switch(config-callhome)# commit
You can discard Call Home configuration changes and release the CFS lock in callhome configuration mode.
Command
switch(config-callhome)# abort

Testing Call Home Communications

You can generate a test message to test your Call Home communications.
Command
switch(config-callhome)# callhome send diagnostic
switch(config-callhome)# callhome test
OL-16597-01
Purpose
Enables Call Home. Disabled by default.
Purpose
Disables Call Home. Disabled by default
Purpose
Enables Call Home distribution using CFS. Disabled
by default.
Purpose
Commits Call Home configuration changes and
distributes the changes to call CFS-enabled devices.
Purpose
Discards Call Home configuration changes and
releases the CFS lock. Use this command if you are
the CFS lock owner or if you are logged into the
device that holds the CFS lock
Purpose
Sends the specified Call Home test message to all
configured destinations.
Sends a test message to all configured destinations.
callhome test and callhome test inventory
commands are supported.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Testing Call Home Communications
361