Configuring Link Notifications - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Configuring SNMP
MIB
CISCO-RSCN-MIB
CISCO-ZS-MIB
The license notifications are enabled by default. All other notifications are disabled by default.
Note
To enable the specified notification in the global configuration mode, perform one of the following tasks:
Command
switch(config)# snmp-server enable traps
switch(config)# snmp-server enable traps aaa
[server-state-change]
switch(config)# snmp-server enable traps entity
[fru]
switch(config)# snmp-server enable traps license
switch(config)# snmp-server enable traps
port-security
switch(config)# snmp-server enable traps snmp
[authentication]

Configuring Link Notifications

You can configure which linkUp/linkDown notifications to enable on a device. You can enable the following
types of linkUp/linkDown notifications:
• Cisco—Cisco NX-OS sends only the Cisco-defined notifications (cieLinkUp, cieLinkDow in
• IETF—Cisco NX-OS sends only the IETF-defined notifications (linkUp, linkDown in IF-MIB) with
OL-16597-01
CISCO-IF-EXTENSION-MIB.my), if ifLinkUpDownTrapEnable (defined in IF-MIB) is enabled for
that interface.
only the defined varbinds, if ifLinkUpDownTrapEnable (defined in IF-MIB) is enabled for that interface.
Related Commands
snmp-server enable traps rscn
snmp-server enable traps rscn els
snmp-server enable traps rscn ils
snmp-server enable traps zone
snmp-server enable traps zone
default-zone-behavior-change
snmp-server enable traps zone merge-failure
snmp-server enable traps zone merge-success
snmp-server enable traps zone request-reject
snmp-server enable traps zone unsupp-mem
Purpose
Enables all SNMP notifications.
Enables the AAA SNMP notifications.
Enables the ENTITY-MIB SNMP notifications.
Enables the license SNMP notification.
Enables the port security SNMP notifications.
Enables the SNMP agent notifications.
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
Configuring Link Notifications
383