Vpc Default Settings; Configuring Vpcs; Enabling Vpcs - Cisco Nexus 3548 Configuration Manual

Configuring Virtual Port Channels
switch(config)# show vpc consistency-parameters vlans
Name
-------------
STP Mode
STP Disabled
STP MST Region Name
STP MST Region Revision
STP MST Region Instance to
VLAN Mapping
STP Loopguard
STP Bridge Assurance
STP Port Type, Edge
BPDUFilter, Edge BPDUGuard
STP MST Simulate PVST
Pass Vlans

vPC Default Settings

The following table lists the default settings for vPC parameters.
Table 6: Default vPC Parameters
Parameters
vPC system priority
vPC peer-keepalive message
vPC peer-keepalive interval
vPC peer-keepalive timeout
vPC peer-keepalive UDP port

Configuring vPCs

Enabling vPCs

You must enable the vPC feature before you can configure and use vPCs.
SUMMARY STEPS
1. switch# configure terminal
2. switch(config)# feature vpc
3. (Optional) switch# show feature
Type Reason Code
---- ---------------------- -----------------------
1 success
1 vPC type-1
configuration
incompatible - STP is
enabled or disabled on
some or all vlans
1 success
1 success
1 success
1 success
1 success
1 success
1 success
-
Default
32667
Disabled
1 second
5 seconds
3200
Cisco Nexus 3548 Switch NX-OS Interfaces Configuration Guide, Release 9x
vPC Default Settings
Pass Vlans
0-4095
0-4,6-4095
0-4095
0-4095
0-4095
0-4095
0-4095
0-4095
0-4095
0-4,6-4095
73