Dhcp Server Global Settings; Dhcp Server Exclude Address Settings - D-Link xStack Reference Manual

®
xStack DGS-3200 Series Layer 2 Managed Gigabit Ethernet Switch Web UI Reference Guide

DHCP Server Global Settings

This window is used to configure the DHCP server global parameters.
To view the following window, click Network Application > DHCP Server > DHCP Server Global Settings:
The following parameters may be configured:
Parameter
DHCP Server State
Ping Packets (0-10)
Ping Timeout (10-
2000)
Click the Apply button to accept the changes made for each individual section.

DHCP Server Exclude Address Settings

The DHCP server assumes that all IP addresses in a DHCP pool subnet are available for assigning to DHCP clients. You must use
this page to specify the IP address that the DHCP server should not assign to clients. This command can be used multiple times in
order to define multiple groups of excluded addresses.
To view the following window, click Network Application > DHCP Server > DHCP Server Exclude Address Settings:
The following parameters may be configured:
Parameter
Begin Address
End Address
Click the Add button to add a new entry based on the information entered. Click the Delete All button to remove all the entries
listed. Click the Delete button to remove the specific entry.
Figure 8 - 6. DHCP Server Global Settings window
Description
Click the radio buttons to enable or disable the DHCP Server State.
Enter the numbers of ping packet that the Switch will send out on the network containing the
IP address to be allotted. If the ping request is not returned, the IP address is considered
unique to the local network and then allotted to the requesting client. 0 means there is no
ping test. The default value is 2.
Enter the amount of time the DHCP server must waits before timing out a ping packet. The
default value is 100.
Figure 8 - 7. DHCP Server Exclude Address Settings window
Description
Enter the starting IP Address.
Enter the ending IP Address.
235