HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual page 81

Note:
serial communication software.
5. At the Windows Workstation menu, click Programs > Accessories >
6. Type Edge Switch 2/24 in the Name field and click OK. The Connect To
7. Ensure the Connect using field displays COM1 or COM2 (depending on the
8. Configure the Port Settings parameters as follows:
9. At the > prompt, type the user-level password (default is password) and
10. At the C> prompt, type ipconfig and press Enter. The Edge Switch 2/24 -
11. Record the switch IP address.
12. Click Exit from the File pull-down menu to close the HyperTerminal
13. Click Yes. A second HyperTerminal dialog box displays.
14. Click No to exit and close the HyperTerminal application.
15. Power off the maintenance terminal.
Edge Switch 2/24 Service Manual
The following steps describe inspecting the IP address using
Communications > HyperTerminal. The Connection Description dialog
box displays
dialog box displays.
serial communication port connection to the switch), and click OK. The
COMn dialog box displays, where n is 1 or 2.
— Bits per second–115200.
— Data bits–8.
— Parity–None.
— Stop bits–1.
— Flow control–Hardware or None.
When the parameters are set, click OK. The Edge Switch 2/24 -
HyperTerminal dialog box displays.
press Enter. The password is case sensitive. The Edge Switch 2/24 -
HyperTerminal dialog box displays with a C> prompt at the bottom of the
window.
HyperTerminal dialog box displays with configuration information listed,
including the IP address.
application. A HyperTerminal dialog box displays.
Diagnostics
HyperTerminal
83