HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual page 189

7. Perform one of the following to verify power supply operation:
8. Perform the data collection procedure. Refer to
9. Perform one of the following to clear the system error (ERR) LED on the
page 32
Edge Switch 2/24 Service Manual
If at the HAFM appliance, open the Hardware View, click Logs > Event
Log. The Event Log displays. Ensure the following event codes appear. If the
event codes do not appear, go to
isolate the problem.
— 207–Power supply installed.
— 313–A cooling fan propeller has recovered (first fan).
— 314–A cooling fan propeller has recovered (second fan).
— 315–A cooling fan propeller has recovered (third fan).
— 203–Power supply AC voltage recovery.
— If at a Web browser connected to the EWS interface, open the Switch tab
at the View panel and ensure no amber LEDs illuminate that indicate a
power supply failure. If a problem is indicated, go to
MAP" on page 32 to isolate the problem.
— If at the HAFM appliance, open the Hardware View and observe the
power supply graphic to ensure no alert symbols appear that indicate a
failure (yellow triangle or red diamond). If a problem is indicated, go to
"MAP 0000: Start
on page 165
for instructions.
switch front bezel:
— If at a Web browser connected to the EWS interface, click the Log tab at
the Monitor panel. The Event Log displays. Click Clear System Error
Light.
— If at the HAFM appliance, open the Hardware View and right-click the
front panel bezel graphic (away from a FRU) to open a menu. Click the
Clear System Error Light menu selection.
"MAP 0000: Start
MAP" on page 32 to isolate the problem.
FRU Removal and Replacement
MAP" on page 32 to
"MAP 0000: Start
"Collecting Maintenance Data"
201