HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual page 226

Fw v06.xx/hafm sw v08.02.00 hp storageworks edge switch 2/24 service manual (aa-rtdxc-te, july 2004)
Hide thumbs Also See for 316095-B21 - StorageWorks Edge Switch 2/24:
Table of Contents

Advertisement

Messages
Table 30:
Performing this action
will overwrite the
date/time on the switch.
Periodic Date/Time
synchronization must be
cleared before enabling
switch clock alert.
Port binding was
removed from attached
devices that are also
participating in Switch
Binding.
Port cannot swap to
itself.
Port diagnostics cannot
be performed on an
inactive port.
Port speeds cannot be
configured at a higher
rate than the
director/switch speed.
Element Manager error
<number>.
Element Manager
instance is currently
open.
242
Element Manager Messages (Continued)
Edge Switch 2/24
Message
Warning that occurs
when configuring the
date and time through
the Configure Date and
Time dialog box, that the
new time or date will
overwrite the existing
time or date set for the
switch.
Action cannot be
performed because
Periodic Date/Time
Synchronization option
is active.
Informational message.
User has removed Port
Binding from attached
devices, but one or more
of these devices is still
controlled by Fabric
Binding.
Port addresses entered
in the Swap Ports dialog
box are the same.
This displays when port
diagnostics is run on a
port in an inactive state.
This displays when you
configure a port to 2
GB/sec and the switch
speed is set to 1 Gb/sec.
The switch Element
Manager encountered
an internal error and
cannot continue.
An Element Manager
window is currently
open.
Description
Edge Switch 2/24 Service Manual
Action
Verify that you want to
overwrite the current date
or time.
Click Periodic Date/Time
Synchronization check box
in Configure Date and
Time dialog box
(Configure menu) to clear
check mark and disable
periodic date/time
synchronization.
Review the Switch Binding
Membership List to
determine if the devices
should be members.
Make sure that address in
the first and second port
address fields are different.
Run the diagnostics on an
active port.
Set the port speed to 1
Gb/sec in the Configure
Operating Parameters
dialog box.
Report the problem to
support personnel.
N/A. Informational
message.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Storageworks edge switch 2/32

Table of Contents