HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual page 248

Event Codes
Table 52: Event Code 150
Message: Zone merge failure.
Severity: Informational.
Explanation: During ISL initialization, the zone merge process failed. Either an incompatible zone
set was detected or a problem occurred during delivery of a zone merge frame. This
event code always precedes a 070 ISL segmentation event code, and represents the
reply of an adjacent fabric element in response to a zone merge frame. Refer to the
event data for the failure reason.
Action: Action depends on the failure reason specified in the event data.
Event Data: Bytes 0–3 of the event data specify affected E_Port number(s). Bytes 8–11 specify the
failure reason as follows:
01 = Invalid data length–An invalid data length condition caused an error in a zone
merge frame. Disconnect the E_Port link, then reconnect the link. If the condition
persists, perform the data collection procedure and return the backup disk to HP
support personnel.
08 = Invalid zone set format–An invalid zone set format caused an error in a zone
merge frame. Disconnect the E_Port link, then reconnect the link. If the condition
persists, perform the data collection procedure and return the backup disk to HP
support personnel.
09 = Invalid data–Invalid data caused a zone merge failure. Inspect bytes 12–15 of
the event data for error codes. Refer to error code definitions listed on the following
page to correct the problem.
0A = Cannot merge–A
Inspect bytes 12–15 of the event data for error codes. Refer to error code definitions
listed on the following page to correct the problem.
F0 = Retry limit reached–A retry limit reached condition caused an error in a zone
merge frame. Disconnect the E_Port link, then reconnect the link. If the condition
persists, perform the data collection procedure and return the backup disk to HP
support personnel.
F1 = Invalid response length–An invalid response length condition caused an error in
a zone merge frame. Disconnect the E_Port link, then reconnect the link. If the
condition persists, perform the data collection procedure and return the backup disk
to HP support personnel.
F2 = Invalid response code–An invalid response code caused an error in a zone
merge frame. Disconnect the E_Port link, then reconnect the link. If the condition
persists, perform the data collection procedure and return the backup disk to HP
support personnel.
266
Cannot Merge
condition caused a zone merge failure.
Edge Switch 2/24 Service Manual