HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual page 225

Table 30:
No file was selected.
No firmware version file
was selected.
No firmware versions to
delete.
Non-redundant switch
must be offline to install
firmware.
Not all of the optical
transceivers are installed
for this range of ports.
Open Trunking is not
installed for this product.
Please contact your sales
representative.
Performing this
operation will change
the current state to
Offline.
Performing this
operation will change
the current state to
Online.
Edge Switch 2/24 Service Manual
Element Manager Messages (Continued)
Edge Switch 2/24
Message
Action requires you to
select a file
A file was not selected in
the Firmware Library
dialog box before an
action, such as modify
or send was performed.
There are no firmware
versions in the firmware
library to delete.
Since the switch has only
a single CTP card, it
must be offline to initiate
a firmware installation.
Note that the CTP card is
an internal component
and not a FRU.
Some ports in the
specified range do not
have optical transceivers
installed.
The Open Trunking
feature key has not been
enabled. This message
only displays if the
optional Open Trunking
feature is installed.
This operation causes
the switch to go offline.
This operation causes
the switch to go online.
Description
Messages
Action
Select a file.
Click a firmware version in
the dialog box to select it,
then perform the action
again.
N/A. An informational
message.
Take switch offline and try
again.
Use a port range that is
valid for the ports installed.
Enter the feature key into
the Configure Feature Key
dialog box and enable the
key. If you require a feature
key, see your account
representative.
N/A. An informational
message.
N/A. An informational
message.
241