HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual page 188

FRU Removal and Replacement
Replacement
To replace a redundant power supply:
1. Remove the replacement power supply from its shipping container.
2. Inspect the rear of the power supply for bent or broken connector pins that
3. Position the power supply in the rear of the switch chassis as shown in part
4. Connect the AC power cord to the power supply and to a facility power
5. Wait several seconds, then inspect the power supply to ensure the amber LED
6. Perform one of the following to inspect the Event Log:
200
may have been damaged during shipping. If any pins are damaged, obtain a
new power supply.
(B) of Figure 56. Ensure the finger handles are disengaged and rotated 90
degrees outward.
a. While supporting the power supply with one hand, insert it into the switch
chassis.
b. Firmly push the power supply into the chassis. Rotate the finger handles
90 degrees inward to seat the power supply and engage the connector
pins. Ensure the faceplate is flush with the chassis cutout.
source.
is extinguished. If the LED is illuminated, go to
page 32 to isolate the problem.
If at a Web browser connected to the EWS interface, click the Log tab at the
Monitor panel. The Event Log displays. Ensure the following event codes
appear. If the event codes do not appear, go to
page 32 to isolate the problem.
— 207–Power supply installed.
— 313–A cooling fan propeller has recovered (first fan).
— 314–A cooling fan propeller has recovered (second fan).
— 315–A cooling fan propeller has recovered (third fan).
— 203–Power supply AC voltage recovery.
"MAP 0000: Start
"MAP 0000: Start MAP" on
Edge Switch 2/24 Service Manual
MAP" on