HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual page 228

Messages
Table 30:
Switch Binding was
removed from attached
devices that are also
participating in Port
Binding. Please review
the Port Binding
Configuration.
System diagnostics
cannot run. The
Operational Status is
invalid.
The add firmware
process has been
aborted.
The data collection
process failed.
The data collection
process has been
aborted.
The default zone must be
disabled to configure.
The switch is busy saving
maintenance
information.
The following
parameters cannot be
disabled while Enterprise
Fabric Mode is active:
Insistent Domain ID,
Rerouting Delay,
Domain RSCN's.
The firmware file is
corrupted.
244
Element Manager Messages (Continued)
Edge Switch 2/24
Message
The device WWNs were
removed from the Switch
Membership List
(SANtegrity Binding
feature), but you should
note that one or more of
these devices still has
security control in port
binding.
System diagnostics
cannot run on switches
with failed ports.
User has ended the add
firmware process.
An error occurred in the
data collection process.
User has ended the data
collection process.
The message displays
when the user attempts
to change the
interoperability mode to
open fabric and the
default zone is enabled
The switch is busy with a
maintenance operation.
User attempted to
disable these parameters
in the Configure Switch
Parameters dialog box
while Enterprise Fabric
Mode is enabled.
A firmware file has
corrupt data.
Description
Edge Switch 2/24 Service Manual
Action
Verify that the security level
for each device is as
required by reviewing the
Bound WWN list in the
Configure Ports dialog
box.
Replace failed ports.
N/A. An informational
message.
Contact support personnel.
N/A. An informational
message.
Disable the default zone
and repeat the operation.
Retry the operation later. If
the condition persists,
contact support personnel.
Disable Enterprise Fabric
Mode through the
Enterprise Fabric Mode
dialog box in the HAFM,
then disable the
parameters.
Contact support personnel.