HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual page 199

Table 29: HAFM application messages (Continued)
Cannot perform
operation. Fabric is
unknown.
Cannot perform
operation. The list of
attached nodes is
unavailable.
Cannot retrieve current
SNMP configuration.
Cannot save current
SNMP configuration.
Cannot set write
authorization without
defining a community
name.
Cannot show zoning
library. No fabric exists.
Click OK to remove all
contents from log.
Connection to HAFM
appliance lost.
Connection to HAFM
appliance lost. Click OK
to exit application.
Edge Switch 2/24 Service Manual
Message
This message displays if
no switches in the fabric
are connected to the
HAFM appliance.
This message displays
when attached nodes are
unavailable and the user
attempts to modify a
zone or create a new
zone.
The current SNMP
configuration could not
be retrieved.
The current SNMP
configuration could not
be saved.
An SNMP community
name is not configured.
The user cannot show the
zoning library if no fabric
exists. A Director or Edge
Switch must be identified
to the
for a fabric to exist.
This action deletes all
contents from the selected
log.
The connection to the
remote HAFM appliance
was lost.
The
a remote workstation lost
the network connection to
the HAFM appliance.
Description
HAFM
application
HAFM
application at
Messages
Action
Ensure at least one
fabric-attached switch or
director has an Ethernet
connection to the HAFM
appliance and retry the
operation.
Verify an attached node is
available and retry the
operation.
Try again. If the problem
persists, contact the next
level of support.
Try again. If the problem
persists, contact the next
level of support.
Enter a valid community
name in the Configure
SNMP dialog box.
Identify a Director or Edge
HAFM
Switch to the
application from the New
Product dialog box.
Click OK to delete the log
contents or Cancel to
cancel the operation.
Log in to the HAFM
appliance again through
the HAFM Login dialog
box.
HAFM
Start the application
to connect to the HAFM
appliance.
215