HP 316095-B21 - StorageWorks Edge Switch 2/24 Service Manual page 55

YES
14
Ensure both power supplies are correctly installed and seated in the switch. If
required, partially remove and reseat the power supplies. Refer to
Redundant Power
Was a corrective action performed?
YES
15
Verify operation of both power supplies.
1. Inspect the power supplies and ensure the amber LEDs are extinguished.
2. At the HAFM appliance Hardware View, observe the graphics representing
Is a dual power supply failure still indicated?
YES
16
Both power supplies failed and must be removed and replaced. Refer to
Redundant Power
Did dual power supply replacement solve the problem?
NO
Edge Switch 2/24 Service Manual
NO
One or both power supplies appear operational, but a power
distribution failure through the CTP card is indicated. Go to
Supply" on page 198.
NO
Go to step 16.
the power supplies and ensure a failure symbol (blinking red and yellow
diamond) does not appear.
NO
The switch appears operational. Exit MAP.
Supply" on page 198.
Perform the data collection procedure as part of FRU removal and
replacement.
Connect the switch to facility AC power after both power supplies are
replaced.
YES
The switch appears operational. Exit MAP.
Diagnostics
step 17.
"RRP:
"RRP:
57